Avaya Scopia XT Series Deployment Manual page 76

Provisioning the XT Series
2. Select the Enable auto-provisioning check box and select Apply.
The server service code for the Equinox Management server displays on the page.
This code can be used as a partial code for post-provisioning an endpoint.
3. To pre-provision the endpoint and generate an endpoint service code, select Endpoints,
and then select Add > Pre-provisioning an Endpoint.
The Pre-provisioning an Endpoint page opens, and the 5-digit server service code
generated in
endpoint service code. This full code enables the XT Series endpoint to connect to the
Equinox Management server when the XT Series administrator activates the pre-
provisioned endpoint, and the endpoint is automatically configured according to the pre-
provisioned profile.
December 2017
Figure 42: Auto-Provisioning Page
Figure 43: Server Service Code
Step 2 on page 76 displays at the top of the page, together with the 7-digit
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
76