Figure 3-2 Networking Diagram For Configuring Trunk - Huawei Quidway S9300 Configuration Manual

3 VLAN Configuration
l
l
l

Figure 3-2 Networking diagram for configuring trunk

VLAN2
Department 1
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure the S9300.
# Create VLAN 2.
<Quidway> system-view
[Quidway] vlan 2
[Quidway-vlan2] quit
# Set the link type of GE 1/0/1 to trunk and add GE 1/0/1 to VLAN 2.
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port link-type trunk
3-28
Department 1 and Department 2 in VLAN 2 are isolated from Department 3 and Department
4 in VLAN 3.
Department 1 and Department 2 in VLAN 2 can communicate with each other.
Department 3 and Department 4 in VLAN 3 can communicate with each other.
GE1/0/1
S9300 GE1/0/2
LSW-A
...... ......
Department
Create VLANs.
Add interfaces to the VLAN.
GE 1/0/1 and GE 1/0/2 belong to VLAN 2.
GE 1/0/3 and GE 1/0/4 belong to VLAN 3.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MAN
S9300
GE1/0/4
GE1/0/3
LSW-B
......
2
Department 3 Department
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
VLAN3
S9300
......
4
Issue 03 (2009-08-20)