Setting Mstp Parameters Of An Interface - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
stp timer max-age max-age
The max age of the S9300 is set.
It is recommended that you run the stp bridge-diameter command to set the network diameter
instead of setting the max age directly. The S9300 calculates the optimal max age according to
the network diameter.
By default, the max age is 2000 centiseconds, that is, 20 seconds.
Step 7 Run:
stp max-hops hop
The maximum number of hops of the spanning tree in an MST region is set.
By default, the maximum number of hops of the spanning tree in an MST region is 20.
----End

8.4.3 Setting MSTP Parameters of an Interface

Context
When MSTP is disabled on an interface, loops may be generated.
Do as follows on the S9300 in an MST region.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
stp { enable | disable }
MSTP is enabled on the interface.
Step 4 Run:
stp edged-port { enable | disable }
The interface is configured as an edge interface.
By default, an interface is a non-edge interface.
Step 5 Run:
stp point-to-point { auto | force-false | force-true }
Issue 03 (2009-08-20)
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 MSTP Configuration
8-17