Assigning An Ip Address To The Vlanif Interface; Optional) Configuring Proxy Arp For The Super-Vlan - Huawei Quidway S9300 Configuration Manual

3 VLAN Configuration
A super-VLAN and sub-VLANs must use different VLAN IDs. A supper-VLAN cannot contain
any physical interfaces.
Step 4 Run:
access-vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>
To add multiple VLANs to a super-VLAN in a batch, ensure that the VLANs meet the conditions
of sub-VLANs.
The S9300 supports 256 sub-VLANs in a super-VLAN.
----End

3.6.4 Assigning an IP Address to the VLANIF Interface

Context
Do as follows on the S9300 where you need to configure VLAN aggregation.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface is created.
The VLANIF interfaces can be configured only for a super-VLAN rather than sub-VLANs.
Therefore, vlan-id specifies the VLAN ID of the super-VLAN.
Step 3 Run:
ip address ip-address { mask | mask-length } [ sub ]
The IP address of the VLANIF interface is configured.
The IP address of the VLANIF interface must reside in the same network segment with the users
of the sub-VLANs.
----End

3.6.5 (Optional) Configuring Proxy ARP for the Super-VLAN

Context
To make proxy ARP take effect, you must configure the IP address for the VLANIF interface
of the super-VLAN.
3-20
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)