Enabling Ldt Globally; Enabling Ldt In A Vlan - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Data Preparation
To configure LDT, you need the following data.
No.
1
2
3
4

10.2.2 Enabling LDT Globally

Context
Do as follows on the S9300.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
loop-detection enable
LDT is enabled globally.
----End

10.2.3 Enabling LDT in a VLAN

Context
Do as follows on the S9300.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
loop-detection enable vlan { vlan-id1 [ to vlan-id2 ] } & <1-10> | all }
LDT is enabled in a VLAN.
Issue 03 (2009-08-20)
Data
ID of the VLAN where LDT is configured
Type and number of each interface to be detected
(Optional) Interval for detecting loops on an interface
(Optional) Recovery time of a blocked interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 LDT Configuration
10-3