Vlan Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
About This Chapter
This chapter describes the basic knowledge, methods, and examples for configuring VLAN.
3.1 Introduction to VLAN
This section describes the concept of the VLAN.
3.2 VLAN Features Supported by the S9300
This section describes the VLAN features supported by the S9300.
3.3 Creating VLANs
This section describes how to create one or multiple VLANs.
3.4 Adding Interfaces to a VLAN
This section describes how to add an access interface, a QinQ interface, a hybrid interface, or a
trunk interface to a VLAN.
3.5 Configuring a VLANIF Interface
This section describes how to create a VLANIF interface and configure the static route.
3.6 Configuring VLAN Aggregation
This section describes how to configure VLAN aggregation to save IP addresses occupied by
VLANs.
3.7 Configuring MUX VLAN
This section describes how to configure interface isolation within a VLAN.
3.8 Configuring VLAN Damping
This section describes how to suppress route flapping on the VLANIF interface.
3.9 Maintaining the VLAN
This section describes how to maintain a VLAN.
3.10 Configuration Examples
This section provides several examples of VLAN configuration.
Issue 03 (2009-08-20)
3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

VLAN Configuration

3 VLAN Configuration
3-1