Checking The Configuration; Configuring Vlan Aggregation; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet

3.5.4 Checking the Configuration

Procedure
Step 1 Run the display interface vlanif [ vlan-id ] [ | { begin | exclude | include } regular-
expression ] command to display basic information about the VLANIF interface.
----End
Example
By running the display interface vlanif command, you can check whether the IP address of a
VLANIF interface is correct.
<Quidway> display interface vlanif
Vlanif1 current state : UP
Line protocol current state : DOWN
Description:HUAWEI, Quidway Series, Vlanif1 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc33-0011
Vlanif30 current state : DOWN
Line protocol current state : DOWN
Description:HUAWEI, Quidway Series, Vlanif30 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 10.10.10.119/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc33-0011

3.6 Configuring VLAN Aggregation

This section describes how to configure VLAN aggregation to save IP addresses occupied by
VLANs.

3.6.1 Establishing the Configuration Task

3.6.2 Configuration Sub-VLANs
3.6.3 Creating a Super-VLAN
3.6.4 Assigning an IP Address to the VLANIF Interface
3.6.5 (Optional) Configuring Proxy ARP for the Super-VLAN
3.6.6 Checking the Configuration
3.6.1 Establishing the Configuration Task
Applicable Environment
VLAN aggregation solves the problem of excessive IP address occupation.
As shown in
form the super-VLAN are called sub-VLANs, which use the same network segment.
Issue 03 (2009-08-20)
Figure 3-1, multiple VLANs are aggregated into a super-VLAN. The VLANs that
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 VLAN Configuration
3-17