Enabling Intra-Vlan Proxy Arp; Checking The Configuration - Huawei Quidway S9300 Configuration Manual

7 ARP Configuration
Intra-VLAN proxy ARP can be enabled on only the VLANIF interface of the S9300.
Step 3 Run:
ip address ip-address { mask | mask-length }
The IP address is assigned to the interface.
The IP address of the interface enabled with intra-VLAN proxy ARP must be on the same
network segment with the IP address of the host connected to this interface, in a LAN.
----End

7.5.3 Enabling Intra-VLAN Proxy ARP

Context
Do as follows on the S9300.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
arp-proxy inner-sub-vlan-proxy enable
Intra-VLAN proxy ARP is enabled.
----End

7.5.4 Checking the Configuration

Prerequisite
The configurations of routed proxy ARP are complete.
Procedure
l
l
l
7-10
Run the display arp [ all ] command to check all the ARP mapping tables, including static
and dynamic ARP entries.
Run the display arp dynamic [ | { begin | exclude | include } regular-expression ]
command to check the dynamic ARP mapping table.
Run the display arp interface interface-type interface-number [ vid vlan-id ] [ | { begin
| exclude | include } regular-expression ] command to check the ARP mapping table on a
specified interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)