Huawei Quidway S9300 Configuration Manual page 113

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
l
Issue 03 (2009-08-20)
The interface view is displayed.
12. Run:
port link-type trunk
The link type of the interface is set to trunk.
13. Run:
port trunk allow-pass vlan vlan-id2
The interface is added to the VLAN specified by the translated VLAN ID.
14. Run:
traffic-policy name1 inbound
The traffic policy is applied in the inbound direction of the interface.
Applying a traffic policy in the outbound direction of an interface
1. Run:
system-view
The system view is displayed.
2. Run:
traffic classifier name2
A traffic classifier is created and the traffic classifier view is displayed.
3. Run:
if-match vlan-id vlan-id2
The packet matching rule, that is, the original VLAN ID of packets matching the
classifier, is set.
4. Run:
quit
Return to the system view.
5. Run:
traffic behavior name2
A traffic behavior is created and the traffic behavior view is displayed.
6. Run:
remark vlan-id vlan-id1
The S9300 is configured to replace the original VLAN ID of the packets matching the
traffic classifier with the specified VLAN ID.
7. Run:
quit
Return to the system view.
8. Run:
traffic policy name2
A traffic policy is created and the policy view is displayed.
9. Run:
classifier name2 behavior name2
The traffic classifier is bound to the traffic behavior in the traffic policy.
10. Run:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 VLAN Mapping Configuration
4-9