Huawei Quidway S9300 Configuration Manual page 57

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Precautions
During the configuration, pay attention to the following:
l
l
l
l
l
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Create an Eth-Trunk.
# Create Eth-Trunk 120.
<Quidway> system-view
[Quidway] sysname S9300
[S9300] interface eth-trunk 120
[S9300-Eth-Trunk120] quit
Step 2 Add member interfaces to the Eth-Trunk.
# Add GE 2/0/0 to Eth-Trunk 120.
[S9300] interface gigabitethernet 2/0/0
[S9300-Gigabitethernet2/0/0] eth-trunk 120
[S9300-Gigabitethernet2/0/0] quit
# Add GE 3/0/0 to Eth-Trunk 120.
[S9300] interface gigabitethernet 3/0/0
[S9300-Gigabitethernet3/0/0] eth-trunk 120
[S9300-Gigabitethernet3/0/0] quit
Step 3 Configure Eth-Trunk 120.
# Configure Eth-Trunk 120 to allow packets of VLANs 100 to 200 to pass through.
Issue 03 (2009-08-20)
The Ethernet interfaces on the two ends that form an Eth-Trunk must be directly connected.
The two ends of the Eth-Trunk must contain the same number of member interfaces.
Before Ethernet interfaces are added to the Eth-Trunk, ensure that no configuration is made
on the Ethernet interfaces.
The Eth-Trunk in manual load balancing mode can contain member interfaces with
different rates. For example, an FE interface and a GE interface can be added to the same
Eth-Trunk.
Each Eth-Trunk contains up to eight member interfaces.
Create an Eth-Trunk.
Add member interfaces to the Eth-Trunk.
Number of the Eth-Trunk
Types and numbers of the member interfaces in the Eth-Trunk
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
2-21