Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
----End

4.5.5 Checking the Configuration

Procedure
l
----End
Example
By running the display current-configuration command in the user view, you can view the
configuration of flow-based VLAN mapping.
<Quidway> display current-configuration
#
traffic classifier name1 operator and precedence 5
if-match 1 vlan-id 10
if-match 2 cvlan-id 20
traffic classifier name2 operator and precedence 10
if-match 1 vlan-id 30
if-match 2 cvlan-id 40
#
traffic behavior name1
remark vlan-id 30
remark cvlan-id 40
traffic behavior name2
remark vlan-id 10
remark cvlan-id 20
#
traffic policy name1
classifier name1 behavior name1
traffic policy name2
classifier name2 behavior name2
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 30
traffic-policy name1 inbound
traffic-policy name2 outbound
Issue 03 (2009-08-20)
A traffic policy is created and the policy view is displayed.
10. Run:
classifier name2 behavior name2
The traffic classifier is bound to the traffic behavior in the traffic policy.
11. Run:
quit
Return to the system view.
12. Run:
interface interface-type interface-number
The interface view is displayed.
13. Run:
traffic-policy name2 outbound
The traffic policy is applied in the outbound direction of the interface.
Run the display current-configuration [ | { begin | exclude | include } regular-
expression ] command to check the configuration of flow-based VLAN mapping.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 VLAN Mapping Configuration
4-15