Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Do as follows on the S9300 where you need to configure proxy ARP.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface is created.
The VLANIF interfaces can be configured only for a super-VLAN rather than sub-VLANs.
Therefore, vlan-id specifies the VLAN ID of the super-VLAN.
Step 3 Run:
arp-proxy enable
Proxy ARP is enabled on the VLANIF interface.
Step 4 Run:
arp-proxy inter-sub-vlan-proxy enable
Proxy ARP is enabled between sub-VLANs.
----End

3.6.6 Checking the Configuration

Procedure
l
l
----End
Example
By running the display vlan verbose command, you can view the VLAN type. The following
is an example:
<Quidway> display vlan 2 verbose
VLAN ID
VLAN Type
Description
Status
Broadcast
MAC learning : Enable
Statistics
Property
Physical status: Down
---------------
sub-VLAN List: 20
Issue 03 (2009-08-20)
Run the display vlan [ vlan-id ] [ statistics | verbose ] command to display information
about a VLAN.
Run the display interface vlanif [ vlan-id ] [ | { begin | exclude | include } regular-
expression ] command to display information about the VLANIF interface.
: 2
: Super
: VLAN 0002
: Enable
: Enable
: Disable
: Default
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 VLAN Configuration
3-21