Configuring Mux Vlan; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual

3 VLAN Configuration
By running the display interface vlanif command, you can see the information including the
physical status, link protocol status, IP address, and mask of the VLANIF interface. The
following is an example:
<Quidway> display interface vlanif 2
Vlanif2 current state : DOWN
Line protocol current state : DOWN
Description:HUAWEI, Quidway Series, Vlanif2 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 10.1.1.1/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc33-0011

3.7 Configuring MUX VLAN

This section describes how to configure interface isolation within a VLAN.

3.7.1 Establishing the Configuration Task

3.7.2 Configuring the MUX VLAN
3.7.3 Configuring the Subordinate VLAN
3.7.4 Enabling the MUX VLAN Function on the Interface
3.7.5 Checking the Configuration
3.7.1 Establishing the Configuration Task
Applicable Environment
A MUX VLAN is used to isolate Layer 2 traffic between the interfaces of a VLAN. For example,
on an intranet, a user interface can communicate with a server interface, but the user interfaces
cannot communicate with each other.
In MUX VLAN implementation, VLANs are classified in to MUX VLANs and subordinate
VLANs. Subordinate VLANs are classified into subordinate group VLANs and subordinate
separate VLANs.
The MUX VLAN can communicate with the subordinate VLANs, but the subordinate VLANs
cannot communicate with each. Interfaces in a subordinate group VLAN can communicate with
each other, but interfaces in a subordinate separate VLAN cannot communicate with each other.
Pre-configuration Tasks
Before configuring the MUX VLAN, complete the following task:
l
Data Preparation
To configure the MUX VLAN, you need the following data.
No.
1
3-22
Creating a VLAN
Data
VLAN ID of the MUX VLAN and interface numbers
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)