Checking The Configuration; Configuring Flow-Based Selective Qinq - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
The interface view is displayed.
Step 3 Run:
port vlan-stacking outside-vlan vlan-id1 [ to vlan-id2 ] stack-vlan vlan-id3
The selective QinQ is configured. The meanings of the parameters are as follows:
l
l
----End

5.4.5 Checking the Configuration

Procedure
Step 1 Run the display current-configuration interface interface-type interface-number command to
display the selective QinQ configuration on the interface.
----End
Example
In the user view, run the display current-configuration interface command. You can check
the configuration of the selected QinQ on the interface.
<Quidway> display current-configuration interface gigabitethernet 3/0/1
#
interface GigabitEthernet3/0/1
port hybrid untagged vlan 2
port vlan-stacking outside-vlan 2 to 5 stack-vlan 2
#
return

5.5 Configuring Flow-based Selective QinQ

This section describes how to set the interface type, the packet matching rule, the outer VLAN
tag added to received packets, and enable the traffic policy to implement flow-based selective
QinQ.
5.5.1 Establishing the Configuration Task
5.5.2 Setting the Link Type of an Interface
5.5.3 Setting the Packet Matching Rule
5.5.4 Adding an Outer VLAN Tag
5.5.5 Configuring a Traffic Policy
5.5.6 Applying the Traffic Policy
5.5.7 Checking the Configuration
Issue 03 (2009-08-20)
vlan-id1 [ to vlan-id2 ] specifies the C-VLAN ID of the VLAN to which you need to add the
VLAN tag.
stack-vlan vlan-id3 specifies the VLAN ID of the outer VLAN tag to be added.
NOTE
An interface learns the MAC address from the outer VLAN tag of a QinQ packet.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 QinQ Configuration
5-7