Adding A Qinq Interface To A Vlan - Huawei Quidway S9300 Configuration Manual

3 VLAN Configuration
Step 3 Run:
port link-type hybrid
The link type of the interface is set to hybrid.
By default, the interface type is hybrid.
Step 4 Run the following commands as required:
l
l
By default, a hybrid interface is added to VLAN 1 in untagged mode.
----End

3.4.5 Adding a QinQ Interface to a VLAN

Context
You can add a QinQ interface to the VLAN in either of the following ways:
Procedure
l
3-12
To add the hybrid interface to a VLAN or multiple VLANs in tagged mode, run port hybrid
tagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10>.
To add the hybrid interface to a VLAN or multiple VLANs in untagged mode, run port
hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10>.
Adding a QinQ interface to a VLAN in the VLAN view
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
port link-type dot1q-tunnel
The link type of the interface is set.
By default, the interface type is hybrid.
4. Run:
quit
Return to the system view.
5. Run:
vlan vlan-id
The VLAN view is displayed.
6. Run:
port interface-type { interface-number1 [ to interface-number2 ] }&<1-10>
The QinQ interface is added to the VLAN, which becomes the default VLAN of the
interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)