Figure 3-4 Networking Diagram For Communication Between Vlans Through Vlanif Interfaces - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Figure 3-4 Networking diagram for communication between VLANs through VLANIF
interfaces
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
Procedure
Step 1 Configure the S9300.
# Create VLANs.
<Quidway> system-view
[Quidway] vlan batch 10 20
# Adding interfaces to the VLANs.
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port link-type trunk
[Quidway-GigabitEthernet1/0/1] port trunk allow-pass vlan 10 20
[Quidway-GigabitEthernet1/0/1] quit
# Assign IP addresses to the VLANIF interfaces.
Issue 03 (2009-08-20)
S9300
GE1/0/1
GE0/0/1
E0/0/1
VLAN 10
PC1
10.10.10.2/24
Add Ethernet interfaces to the VLAN.
Configure VLANIF interfaces.
Add GE 1/0/1 of the S9300 to VLAN 10 and VLAN 20.
Set the IP address of VLANIF 10 on the S9300 to be 10.10.10.1/24.
Set the IP address of VLANIF 20 on the S9300 to be 20.20.20.1/24.
Add GE 0/0/1 of SwitchA to VLAN 10 and VLAN 20.
Add Ethernet 0/0/1 of SwitchA to VLAN 10.
Add Ethernet 0/0/2 of SwitchA to VLAN 20.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchA
E0/0/2
VLAN 20
PC2
20.20.20.2/24
3 VLAN Configuration
3-33