Configuring The Advanced Attributes Of An Ethernet Interface; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual

1 Ethernet Interface Configuration
Speed : 1000,
Duplex: FULL,
Mdi
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Input:
Unicast:
Discard:
Jumbo
Output: 0 packets, 0 bytes
Unicast:
Discard:
Jumbo
1.4 Configuring the Advanced Attributes of an Ethernet
Interface
This section describes how to configure the loopback test, interface group, maximum size of an
Ethernet frame, flow control, auto-negotiation of flow control parameters, interface security,
and cable detection.

1.4.1 Establishing the Configuration Task

1.4.2 (Optional) Configuring Loopback Test on the Ethernet Interface
1.4.3 (Optional) Configuring the Interface Group
1.4.4 (Optional) Setting the Maximum Frame Length on the Ethernet Interface
1.4.5 (Optional) Enabling Flow Control
1.4.6 (Optional) Enabling Auto-Negotiation of Flow Control
1.4.7 (Optional) Enabling the Interface Protection Function
1.4.8 (Optional) Enabling Interface Cable Test
1.4.9 Checking the Configuration
1.4.1 Establishing the Configuration Task
Applicable Environment
The configuration task is applicable in the following situations:
l
l
1-8
Loopback: NONE
Negotiation: ENABLE
: NORMAL
0 packets, 0 bytes
0, NUnicast:
0, Error
: 0
0, NUnicast:
0, Error
: 0
The S9300 provides the interface group function, which enables you to configure multiple
interfaces at the same time.
When the traffic volume received on an interface of the S9300 exceeds the processing
capability of the interface and the directly connected interface supports traffic control, you
can enable the traffic control function on the interface of the S9300. After traffic control is
enabled on the interface, the interface sends a Pause frame to the peer interface to request
the peer interface to stop sending traffic if the received traffic reaches the set threshold. If
the peer interface supports traffic control, the peer interface decreases the rate of sending
traffic after receiving the frame so that the local interface can properly process received
traffic.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
0
: 0
0
: 0
Configuration Guide - Ethernet
Issue 03 (2009-08-20)