Huawei Quidway S9300 Configuration Manual page 93

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
l
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Create VLANs.
# Create VLAN 100 and VLAN 3000.
<Quidway> system-view
[Quidway] sysname S9300
[S9300] vlan batch 100 3000
Step 2 Configure the interface connected to Internet access users.
# Add GE 1/0/0 to VLAN 100.
[S9300] interface gigabitethernet 1/0/0
[S9300-GigabitEthernet1/0/0] port link-type access
[S9300-GigabitEthernet1/0/0] port default vlan 100
[S9300-GigabitEthernet1/0/0] quit
Step 3 Configure the interface connected to the enterprise user.
# Add GE 1/0/5 to VLAN 3000.
[S9300] interface gigabitethernet 1/0/5
[S9300-GigabitEthernet1/0/5] port link-type access
[S9300-GigabitEthernet1/0/5] port default vlan 3000
[S9300-GigabitEthernet1/0/5] quit
Step 4 Configure the interface connected to the switch.
# Add GE 2/0/0 to VLAN 100 and VLAN 3000 so that GE 2/0/0 allows packets from VLAN
100 and VLAN 3000 to pass through.
[S9300] interface gigabitethernet 2/0/0
[S9300-GigabitEthernet2/0/0] port link-type trunk
[S9300-GigabitEthernet2/0/0] port trunk allow-pass vlan 100 3000
[S9300-GigabitEthernet2/0/0] quit
Step 5 Verify the configuration.
# Display the configuration of VLAN 100.
[S9300] display vlan 100
VLAN ID Type
Issue 03 (2009-08-20)
In this configuration example, the user-side interfaces of the S9300 are access interfaces,
and the network-side interface is a trunk interface.
Create VLANs.
Add user-side interfaces to VLANs.
Configure the uplink interface of the S9300 as a trunk interface.
IDs of the VLANs that the users belong to
Numbers of user-side and network-side interfaces
Status
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MAC Learning Broadcast/Multicast/Unicast Property
3 VLAN Configuration
3-31