2.3.2 Creating an Eth-Trunk............................................................................................................................2-4

2.3.3 Configuring the Eth-Trunk to Work in Manual Load Balancing Mode.................................................2-5

2.3.4 Adding Member Interfaces to an Eth-Trunk..........................................................................................2-5

2.3.5 (Optional) Configuring the Load Balancing Mode................................................................................2-6

2.3.6 Checking the Configuration...................................................................................................................2-7

2.4 Configuring Enhanced Link Aggregation in Manual Load Balancing Mode.................................................2-8

2.4.1 Establishing the Configuration Task......................................................................................................2-8

2.4.2 Configuring a Profile of Enhanced Eth-Trunks in Manual Load Balancing Mode...............................2-9

2.4.3 Configuring an Enhanced Eth-Trunk in Manual Load Balancing Mode.............................................2-10

2.4.4 Checking the Configuration.................................................................................................................2-10

2.5 Configuring Link Aggregation in Static LACP Mode..................................................................................2-11

2.5.1 Establishing the Configuration Task....................................................................................................2-11

2.5.2 Configuring the Eth-Trunk to Work in Static LACP Mode.................................................................2-12

2.5.3 Adding Member Interfaces to an Eth-Trunk........................................................................................2-13

2.5.4 (Optional) Setting the LACP Priority of the System............................................................................2-14

2.5.5 (Optional) Limiting the Number of Active Interfaces..........................................................................2-14

2.5.6 (Optional) Setting the LACP Priority of the Interface.........................................................................2-15

2.5.7 (Optional) Enabling LACP Preemption and Setting the Delay for LACP Preemption.......................2-16

2.5.8 (Optional) Setting the Timeout Interval for Receiving LACP Packets................................................2-17

2.5.9 Checking the Configuration.................................................................................................................2-17

2.6 Maintaining Link Aggregation......................................................................................................................2-18

2.6.1 Clearing Statistics of LACP Packets....................................................................................................2-18

2.6.2 Debugging the Link Aggregation Group.............................................................................................2-19

2.6.3 Monitoring the Operation Status of the Link Aggregation Group.......................................................2-19

2.7 Configuration Examples................................................................................................................................2-20

2.7.1 Example for Configuring Link Aggregation in Manual Load Balancing Mode..................................2-20

2.7.2 Example for Configuring Link Aggregation in Static LACP Mode....................................................2-22

3 VLAN Configuration.................................................................................................................3-1

3.1 Introduction to VLAN.....................................................................................................................................3-2

3.2 VLAN Features Supported by the S9300........................................................................................................3-2

3.3 Creating VLANs.............................................................................................................................................3-5

3.3.1 Establishing the Configuration Task......................................................................................................3-5

3.3.2 Creating a VLAN...................................................................................................................................3-6

3.3.3 (Optional) Creating VLANs in a Batch..................................................................................................3-6

3.3.4 (Optional) Enabling Traffic Statistic in a VLAN...................................................................................3-7

3.3.5 (Optional) Disabling MAC Address Learning on a VLAN...................................................................3-7

3.3.6 Checking the Configuration...................................................................................................................3-8

3.4 Adding Interfaces to a VLAN.........................................................................................................................3-9

3.4.1 Establishing the Configuration Task......................................................................................................3-9

3.4.2 Adding an Access Interface to a VLAN.................................................................................................3-9

3.4.3 Adding a Trunk Interface to a VLAN..................................................................................................3-11

3.4.4 Adding a Hybrid Interface to a VLAN.................................................................................................3-11

Huawei Proprietary and Confidential

Quidway S9300 Terabit Routing Switch

Configuration Guide - Ethernet

Issue 03 (2009-08-20)

Table of Contents