Configuring A Pe Interface At The Psn Side To Forward Bpdus With The Specified Vlan Tags - Huawei Quidway S9300 Configuration Manual
Terabit routing switch
Hide thumbs
Also See for Quidway S9300:
- Configuration manual - network management (630 pages) ,
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages)
Table of Contents
Advertisement
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
l
----End
9.3.5 Configuring a PE Interface at the PSN Side to Forward BPDUs
with the Specified VLAN Tags
Do as follows on the PE devices.
Issue 03 (2009-08-20)
The view of the PE interface at the CE side is displayed.
4.
Run:
stp disable
STP is disabled and the PE interface is configured not to participate in calculation of
the spanning tree.
NOTE
After the preceding configuration is complete, the PE can transparently transmit BPDUs from CE
devices. You do not need to enable the BPDU tunnel function.
Configuration for the PE and CE devices of the same role
1.
Run the following command on the PE devices:
system-view
The system view is displayed.
2.
(Optional) Run:
bpdu-tunnel stp group-mac group-mac
The destination MAC address of BPDUs is replaced by the specified MAC address.
The well-known destination MAC address of BPDUs can be replaced with only a
multicast MAC address. The specified multicast MAC address, however, cannot be
the reserved multicast MAC addresses 0180-C200-0000 to 0180-C200-002F.
By default, the multicast MAC address used to replace the well-known destination
MAC address of BPDUs is 0100-0ccd-cdd0.
3.
Run:
interface interface-type interface-number
The view of the PE interface at the CE side is displayed.
4.
Run:
stp disable
STP is disabled and the PE interface is configured not to participate in calculation of
the spanning tree.
5.
Run:
bpdu-tunnel enable
The BPDU tunnel function is enabled and the PE interface can transparently transmit
BPDUs of user networks.
NOTE
If PE and CE devices play the same role, the PE can transparently transmit the BPDUs from the CE
only when the BPDU tunnel function is enabled.
If PE and CE devices play the same role, no special configuration is required on the P device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BPDU Tunnel Configuration
9-11
Advertisement
Table of Contents
