Configuring Fast Transition Mechanism On An Interface - Huawei Quidway S9300 Configuration Manual

8 MSTP Configuration
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run either of the following commands as required.
l
l
Step 3 Run:
stp compliance { auto | dot1s | legacy }
The format of MSTP packets on the interface is set.
By default, the format of the received and sent MSTP packets is auto.
----End

8.4.6 Configuring Fast Transition Mechanism on an Interface

Context
Do as follows on the devices in the MST region.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run either of the following commands as required:
l
l
Step 3 Run:
stp no-agreement-check
The fast transition mechanism is configured on an interface.
8-20
Run:
interface interface-type interface-number
The Ethernet interface view or GE interface view is displayed.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
NOTE
If the format of MSTP packets is set to dotls on one end and legacy on the other end, the negotiation fails.
Run:
interface interface-type interface-number
The Ethernet interface view is displayed.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)