Creating A Static Arp Entry - Huawei Quidway S9300 Configuration Manual

7 ARP Configuration
To configure dynamic ARP, you need the following data.
No.
1
2

7.3.2 Creating a Static ARP Entry

Context
Do as follows on the S9300.
If both static ARP and Virtual Router Redundancy Protocol (VRRP) are enabled on the
S9300, the virtual IP address of the VRRP virtual device configured on the VLANIF interface
cannot be used as the IP address contained in the static ARP entry; otherwise, incorrect host
routes are generated and hence packet forwarding is affected.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run the command to add a static ARP entry.
Create static ARP entries according to different configuration items.
l
l
l
7-4
Data
Number of detection times before deleting dynamic ARP entries
Aging time of dynamic ARP entries
CAUTION
If no outgoing interface is specified for the configured static ARP entry, this static ARP entry
cannot be used to forward packets.
To create a static entry in a VLAN, run:
If the VLANIF interface is bound to a VPN instance, run:
–
arp static ip-address mac-address vid vlan-id interface interface-type
interface-number
If the VLANIF interface is bound to a VPN instance, the device automatically associates
the static ARP entry with the VPN instance. This command is applied to the port-based
VLAN.
If the interface is bound to a VPN instance, run:
–
arp static ip-address mac-address [ vpn-instance vpn-instance-name ] vidvlan-
id
To create a static ARP entry in a VPN instance, run:
arp static ip-address mac-address vpn-instance vpn-instance-name
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)