Figure 2-6 Networking Diagram For Configuring Link Aggregation In Static Lacp Mode - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Networking Requirements
To improve the bandwidth and the connection reliability, configure the link aggregation group
on two directly connected S9300s, as shown in
l
l

Figure 2-6 Networking diagram for configuring link aggregation in static LACP mode

S9300-A
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Create Eth-Trunk 1 and set the load balancing mode of the Eth-Trunk to static LACP mode.
# Configure S9300-A.
<Quidway> system-view
[Quidway] sysname S9300-A
[S9300-A] interface eth-trunk 1
[S9300-A-Eth-Trunk1] mode lacp-static
[S9300-A-Eth-Trunk1] quit
# Configure S9300-B.
Issue 03 (2009-08-20)
M active links can implement load balancing.
N links between two S9300s can carry out redundancy backup. When a fault occurs on an
active link, the backup link replaces the faulty link to keep the reliability of data
transmission.
Eth-Trunk 1
GE 1/0/1
GE 1/0/2
Eth-Trunk
GE 1/0/3
Create an Eth-Trunk on the S9300 and configure the Eth-Trunk to work in static LACP
mode.
Add member interfaces to the Eth-Trunk.
Set the system priority and determine the Actor.
Set the upper threshold of the active interfaces.
Set the priority of the interface and determine the active link.
Numbers of the link aggregation groups on the S9300s
System priority of S9300-A
Upper threshold of active interfaces
LACP priority of the active interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
Figure 2-6. The requirements are as follows:
Eth-Trunk 1
S9300-B
GE 1/0/1
GE 1/0/2
GE 1/0/3
Active link
Backup link
2-23