Huawei Quidway S9300 Configuration Manual page 258

9 BPDU Tunnel Configuration
l
9-22
The system view is displayed.
2. Run:
bpdu-tunnel stp bridge role provider
The PE or P device is configured as a provider.
3. Run:
interface interface-type interface-number
The view of the PE interface at the CE side is displayed.
4. (Optional) Run:
port link-type { hybrid | trunk }
The link type of the PE interface is set.
By default, the type of an interface is hybrid.
5. Run:
port hybrid untagged vlan vlan-id3
The interface is added to the stacked outer VLAN.
6. Run:
port vlan-stacking outside-vlan vlan-id1 [ to vlan-id2 ] stack-vlan vlan-
id3
The PE is configured to add outer tags to the received BPDUs.
7. Run:
stp disable
STP is disabled and the PE interface is configured not to participate in calculation of
the spanning tree.
Configuration for the PE and CE devices of the same role
1. Run the following command on the PE devices:
system-view
The system view is displayed.
2. (Optional) Run:
bpdu-tunnel stp group-mac group-mac
The destination MAC address of BPDUs is replaced by the specified MAC address.
The well-known destination MAC address of BPDUs can be replaced with only a
multicast MAC address. The specified multicast MAC address, however, cannot be
the reserved multicast MAC addresses 0180-C200-0000 to 0180-C200-002F.
By default, the multicast MAC address used to replace the well-known destination
MAC address of BPDUs is 0100-0ccd-cdd0.
3. Run:
interface interface-type interface-number
The view of the PE interface at the CE side is displayed.
4. Run:
port hybrid untagged vlan vlan-id3
The interface is added to the stacked outer VLAN.
5. Run:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)