Huawei Quidway S9300 Configuration Manual page 248

9 BPDU Tunnel Configuration
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The view of the PE interface at the PSN side is displayed.
Step 3 Run:
port link-type trunk
The link type of the interface is set to trunk.
Step 4 Run:
port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }
The PE interface is configured to forward BPDUs with the specified VLAN tags.
----End
9.3.6 Checking the Configuration
Procedure
Step 1 Run the display stp [ brief ] command to check information about the spanning tree.
----End
Example
Run the display stp [ brief ] command on each CE device, and you can find that STP is enabled
on the interfaces of the CE devices. The designated port and root port are correct. The following
is an example:
<Quidway1> display stp
-------[CIST Global Info] [Mode MSTP] -------
CIST Bridge
Bridge Times
CIST Root/ERPC
CIST RegRoot/IRPC
CIST RootPortId
BPDU-Protection
TC or TCN received
STP Converge Mode
Time since last TC received :0 days 2h:24m:36s
----[Port1(GigabitEthernet1/0/0)] [FORWARDING] ----
Port Protocol
Port Role
Port Priority
Port Cost(Dot1T )
Desg. Bridge/Port
Port Edged
Point-to-point
Transit Limit
Protection Type
PortTimes
BPDU Sent
9-12
:32768.00e0-fc9f-3257
:Hello 2s MaxAge 20s FwDly 15s MaxHop 20
:32768.00e0-fc9a-4315 / 199999
:32768.00e0-fc9f-3257 / 0
:128.82
:disabled
:6
:Fast
:enabled
:CIST Root Port
:128
:Config=auto / Active=199999
:32768.00e0-fc9a-4315 / 128.82
:Config=disabled / Active=disabled
:Config=auto / Active=true
:3 packets/hello-time
:None
:Hello 2s MaxAge 20s FwDly 15s RemHop 0
:6
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)