Checking The Configuration; Setting The Protocol Type In The Outer Vlan Tag; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet

5.5.7 Checking the Configuration

Procedure
Step 1 Run the display current-configuration command to check the configuration of flow-based
selective QinQ.
----End
Example
By running the display current-configuration command in the user view, you can view the
configuration of the selective QinQ.
<Quidway> display current-configuration
#
traffic classifier classifier-name operator or precedence 5
if-match 1 cvlan-id 500
#
traffic behavior behavior-name
nest top-most vlan-id 200
#
traffic policy policy-name
classifier classifier-name behavior behavior-name
#
interface GigabitEthernet9/0/10
port hybrid untagged vlan 200
traffic-policy policy-name inbound
#
return

5.6 Setting the Protocol Type in the Outer VLAN Tag

This section describes how to set the protocol type in the outer VLAN tag on an interface.

5.6.1 Establishing the Configuration Task

5.6.2 Setting the Link Type of an Interface
5.6.3 Setting the Protocol Type of the Outer VLAN Tag
5.6.4 Checking the Configuration
5.6.1 Establishing the Configuration Task
Applicable Environment
To enable the S9300 to communicate with devices of other vendors, you need to set a protocol
type that can be identified by the peer device in the outer VLAN tag.
Pre-configuration Tasks
None.
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 QinQ Configuration
5-11