Adding Interfaces To A Vlan; Establishing The Configuration Task; Adding An Access Interface To A Vlan - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet

3.4 Adding Interfaces to a VLAN

This section describes how to add an access interface, a QinQ interface, a hybrid interface, or a
trunk interface to a VLAN.

3.4.1 Establishing the Configuration Task

3.4.2 Adding an Access Interface to a VLAN

3.4.3 Adding a Trunk Interface to a VLAN
3.4.4 Adding a Hybrid Interface to a VLAN
3.4.5 Adding a QinQ Interface to a VLAN
3.4.6 (Optional) Specifying the Default VLAN of a Trunk Interface
3.4.7 (Optional) Specifying the Default VLAN of a Hybrid Interface
3.4.8 Checking the Configuration
3.4.1 Establishing the Configuration Task
Applicable Environment
You can configure VLANs based on interfaces. You can group the interfaces that process the
same service into a VLAN. In this manner, the interfaces that process different services are
isolated. For example, interface 1 and interface 2 connect to broadband access users; interface
3 connects to users of video services. In this case, interface 1 and interface 2 are grouped into a
VLAN; interface 3 is added into a different VLAN.
Pre-configuration Tasks
Before adding interfaces to a VLAN, complete the following task:
l
Data Preparation
To add interfaces to a VLAN, you need the following data.
No.
1
2
3.4.2 Adding an Access Interface to a VLAN
Issue 03 (2009-08-20)
Creating a VLAN
Data
Types and numbers of the interfaces to be added to a VLAN
VLAN ID
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 VLAN Configuration
3-9