Configuring Selective Qinq; Establishing The Configuration Task; Setting The Link Type Of An Interface - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet

5.4 Configuring Selective QinQ

This section describes how to configure the interface type, the outer VLAN ID, and selective
QinQ.

5.4.1 Establishing the Configuration Task

5.4.2 Setting the Link Type of an Interface

5.4.3 Adding an Outer VLAN Tag
5.4.4 Configuring Selective QinQ
5.4.5 Checking the Configuration
5.4.1 Establishing the Configuration Task
Applicable Environment
To enable users to communicate through the ISP network, user packets are added an outer VLAN
tag.
Pre-configuration Tasks
None
Data Preparation
To configure selective QinQ, you need the following data.
No.
1
2
3
5.4.2 Setting the Link Type of an Interface
Context
Do as follows on the S9300 to be configured with selective QinQ:
Procedure
Step 1 Run:
system-view
Issue 03 (2009-08-20)
Data
Number of the interface to be configured with selective QinQ
Inner VLAN ID to be replaced
Outer VLAN ID
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 QinQ Configuration
5-5