Optional) Configuring The Load Balancing Mode - Huawei Quidway S9300 Configuration Manual

2 Link Aggregation Configuration
l
----End

2.3.5 (Optional) Configuring the Load Balancing Mode

Context
Do as follows on the S9300 where you need to configure the load balancing mode of Eth-Trunk.
2-6
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
3. Run:
trunkport interface-type { interface-number1 [ to interface-number2 ] }
&<1-8>
Member interfaces are added to the Eth-Trunk.
Configuration in the member interface view
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
eth-trunk trunk-id
The interface is added to the Eth-Trunk.
When adding an interface to an Eth-Trunk, pay attention to the following points:
An Eth-Trunk contains a maximum of eight member interfaces.
–
A member interface cannot be configured with any service or static MAC address.
–
An Eth-Trunk cannot be nested, that is, its member interfaces cannot be Eth-Trunk.
–
An Ethernet interface can be added to only one Eth-trunk interface. To add the Ethernet
–
interface to another Eth-trunk, delete the Ethernet interface from the current Eth-Trunk
first.
The member interfaces of an Eth-trunk must be of the same type, that is, the FE interface
–
and the GE interface cannot be added to the same Eth-trunk.
Ethernet interfaces on different LPUs can be added to the same Eth-Trunk.
–
The peer interface directly connected to the Eth-Trunk on the local end must also be
–
added to an Eth-Trunk; otherwise, the two ends cannot communicate.
When the rates of member interfaces are different, the interfaces with a smaller rate may
–
be congested, and thus packets may be lost.
After an interface is added to an Eth-Trunk, MAC address learning is performed by the
–
Eth-Trunk rather than the member interfaces.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)