Configuring A Trunk - Huawei Quidway S1700 Series Web User Manual

Quidway S1700 Series Ethernet Switches
Web User Manual

4.2.2 Configuring a Trunk

Use the Interface > Trunk > Static page to create a trunk, assign member ports, and configure
the connection parameters.
To create a static trunk:
1. Click Interface > Trunk > Static.
Figure 4-9 Creat a Trunk
2. Select Add from the Action list. Enter a trunk identifier, and mark the ports assigned to each
trunk. See
Table 4-6 Parameters of Creating a Trunk
Title
Mode
Trunk ID
Trunk Member Port
List
3. Click Apply.
----End
To show/delete the trunks configured on the switch:
1. Click Interface > Trunk > Static.
2. Select Show/Delete from the Action list.
Issue 01 (2011-11-17)
When configuring trunks, you may not be able to link switches of different types,
depending on the manufacturer's implementation. However, note that the static trunks on
this switch are Cisco EtherChannel compatible.
To avoid creating a loop in the network, be sure you add a trunk via the configuration
interface before connecting the ports, and also disconnect the ports before removing a
static trunk via the configuration interface.
Table 4-6 for the description of parameters of creating a trunk.
Description
Manual mode(Manually port aggregation) or static mode (Static
LACP port aggregation), 12 groups of up to 8 ports.
Trunk identifier. (Range: 1-12)
The ports assigned to a trunk.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Figure 4-9 is displayed.
Figure 4-10 is displayed.
4 Interface Configuration
32