Arp Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
About This Chapter
This chapter describes the principle of the Address Resolution Protocol (ARP), and provides
configuration procedures and examples of ARP.
7.1 Introduction to ARP
This section describes the basic concepts and principle of ARP.
7.2 ARP Features Supported by the S9300
This section describes the ARP features supported by the S9300.
7.3 Configuring ARP
This section describes how to configure static ARP and dynamic ARP. Dynamic ARP entries
are maintained by ARP, but you can optimize dynamic ARP entries by setting the number of
detection times before deleting dynamic ARP entries, aging time of dynamic ARP entries, and
other parameters.
7.4 Configuring Routed Proxy ARP
This section describes how to configure routed proxy ARP to ensure the interconnection between
different subnets.
7.5 Configuring Intra-VLAN Proxy ARP
This section describes how to configure intra-VLAN proxy ARP so that isolated hosts in a VLAN
can communicate.
7.6 Configuring Inter-VLAN Proxy ARP
This section describes how to configure inter-VLAN proxy ARP so that sub-VLANs in a super-
VLAN can communicate.
7.7 Configuring ARPing-IP
This section describes how to configure ARPing-IP to check whether an IP address is used by
another device.
7.8 Maintaining ARP
This section describes how to maintain ARP.
7.9 Configuration Examples
This section provides several configuration examples of ARP.
Issue 03 (2009-08-20)
7
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

ARP Configuration

7 ARP Configuration
7-1