Configuring A Vlanif Interface; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Input:
Unicast:
Discard:
Jumbo
Output: 0 packets, 0 bytes
Unicast:
Discard:
Jumbo
By running the display vlan vlan-id command, you can see that GigabitEthernet 1/0/1 is added
to VLAN 2.
<Quidway> display vlan 2
VLAN ID Type
----------------------------------------------------------
2
----------------
Untagged
----------------
Interface
GigabitEthernet1/0/1

3.5 Configuring a VLANIF Interface

This section describes how to create a VLANIF interface and configure the static route.

3.5.1 Establishing the Configuration Task

3.5.2 Creating a VLANIF Interface
3.5.3 Assigning an IP Address to the VLANIF Interface
3.5.4 Checking the Configuration
3.5.1 Establishing the Configuration Task
Applicable Environment
When the S9300 needs to communicate with devices at the network layer, you can create a
logical interface based on the VLAN on the S9300, namely, a VLANIF interface. You can assign
IP addresses to VLANIF interfaces because VLANIF interfaces work at the network layer. The
S9300 then communicates with the devices at the network layer through VLANIF interfaces.
Pre-configuration Tasks
Before creating a VLANIF interface, complete the following task:
l
Data Preparation
To create a VLANIF interface, you need the following data.
Issue 03 (2009-08-20)
0 packets, 0 bytes
0, NUnicast:
0, Error
: 0
0, NUnicast:
0, Error
: 0
Status
common enable
Port: GigabitEthernet1/0/1
Creating VLANs
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
0
: 0
0
: 0
MAC Learning Broadcast/Multicast/Unicast Property
enable forward
Physical
UP
3 VLAN Configuration
forward forward default
3-15