Optional) Specifying The Default Vlan Of A Hybrid Interface; Checking The Configuration - Huawei Quidway S9300 Configuration Manual

3 VLAN Configuration

3.4.7 (Optional) Specifying the Default VLAN of a Hybrid Interface

Context
Do as follows on the S9300 where you specify the default VLAN of a hybrid interface.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
port link-type hybrid
The link type of the interface is set to hybrid.
By default, the interface type is hybrid.
Step 4 Run:
port hybrid pvid vlan vlan-id
The default VLAN of the hybrid interface is specified.
By default, VLAN 1 is the default VLAN of hybrid interfaces.
----End

3.4.8 Checking the Configuration

Procedure
l
l
----End
Example
By running the display interface [ interface-type [ interface-number ] ] command, you can see
that the PVID of GigabitEthernet 2/0/1 is 6.
<Quidway> display interface gigabitethernet 2/0/1
Description:HUAWEI, Quidway Series, GigabitEthernet2/0/1 Interface
Switch Port,PVID :
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc33-0011
Port Mode: FORCE FIBER
Speed : 1000,
Duplex: FULL,
Mdi
3-14
Run the display interface [ interface-type [ interface-number ] ] command to display the
VLAN where the interface is added.
Run the display vlan vlan-id command to display basic information about the VLAN.
6,The Maximum Frame Length is 1536
Loopback: NONE
Negotiation: ENABLE
: NORMAL
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)