Configuring Trunk Port Attribute; Copying Port Configuration To Other Ports - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Port
Quidway S3100 Series Ethernet Switches

1.2.6 Configuring Trunk Port Attribute

Table 1-8 Configure trunk port attribute
Enter system view
Enter Ethernet port view
Set the link type for the
port as trunk
Set the default VLAN ID
for the trunk port
Add the current trunk
port into the specified
VLAN

1.2.7 Copying Port Configuration to Other Ports

To keep the configuration of some other ports consistent with a specified port, you can
copy the configuration of the specified port to these ports.
The configuration may include:
VLAN settings: Includes the permitted VLAN types and default VLAN ID.
QoS settings: Includes traffic limiting, priority marking and default 802.1p priority.
STP settings: Includes STP enabling/disabling, link attribute (point-to-point or not),
STP priority, path cost, maximum transmission speed, loop protection, root
protection, and edge port or not.
Port setting: Includes port link type, port speed, and duplex mode.
Table 1-9 Copy port configuration to other ports
Operation
Enter system view
Copy
configuration
other ports
Operation
System-view
interface
interface-number
port link-type trunk
port trunk pvid vlan
vlan-id
port trunk permit vlan
{ vlan-id-list | all }
system-view
copy configuration source { interface-type
port interface-number
to source-agg-id } destination { interface-list
[ aggregation-group destination-agg-id ] |
aggregation-group destination-agg-id }
Huawei Technologies Proprietary
Chapter 1 Basic Port Configuration
Command
interface-type
Command
| aggregation-group
1-7
Remarks
—
—
Required
Optional
By default, the VLAN of a
trunk port is VLAN 1.
Optional
Remarks
—
Optional