Huawei Quidway S9300 Configuration Manual page 196

7 ARP Configuration
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Create VLAN 2 and add GE 1/0/0 to VLAN 2.
<Quidway> system-view
[Quidway] vlan 2
[Quidway-vlan2] quit
[Quidway] interface gigabitethernet 1/0/0
[Quidway-GigabitEthernet1/0/0] port link-type access
[Quidway-GigabitEthernet1/0/0] port default vlan 2
[Quidway-GigabitEthernet1/0/0] quit
Step 2 Create and configure VLANIF 2.
[Quidway]
[Quidway-Vlanif2] ip address 172.16.1.1 255.255.255.0
Step 3 Enable routed proxy ARP on VLANIF 2.
[Quidway-Vlanif2] arp-proxy enable
[Quidway-Vlanif2] quit
Step 4 Create VLAN 3 and add GE 1/0/1 to VLAN 3.
[Quidway] vlan 3
[Quidway-vlan3] quit
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port link-type access
[Quidway-GigabitEthernet1/0/1] port default vlan 3
[Quidway-GigabitEthernet1/0/1] quit
Step 5 Create and configure VLANIF 3.
[Quidway] interface vlanif 3
[Quidway-Vlanif3] ip address 172.16.2.1 255.255.255.0
Step 6 Enable routed proxy ARP on VLANIF 3.
[Quidway-Vlanif3] arp-proxy enable
[Quidway-Vlanif3] quit
Step 7 Configure the hosts.
# Assign IP address 172.16.1.2/16 to Host A.
# Assign IP address 172.16.2.2/16 to Host B.
Step 8 Verify the configuration.
# Ping Host B from Host A. The ping operation is successful.
# Check the ARP table of Host A, and you can view that the MAC address corresponding to
Host B is the MAC address of GE 1/0/0 on S9300-A.
C:\Documents and Settings\Administrator>arp -a
Interface: 172.16.1.2 --- 0x2
7-20
Enable routed proxy ARP on the interface.
Configure the default route.
IP addresses of the interfaces
Default route
IP addresses of the hosts
interface vlanif 2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)