Maintaining The Vlan; Clearing Statistics On A Vlan; Configuration Examples; Example For Configuring The Trunk - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet

3.9 Maintaining the VLAN

This section describes how to maintain a VLAN.

3.9.1 Clearing Statistics on a VLAN

3.9.1 Clearing Statistics on a VLAN
Context
The statistics on a VLAN cannot be restored after you clear them. So, confirm the action before
you use the command.
Before clearing the statistics on a VLAN, enable the statistics function in the VLAN.
Procedure
Step 1 Run the reset vlan vlan-id statistics command to clear statistics on a VLAN.
----End

3.10 Configuration Examples

This section provides several examples of VLAN configuration.

3.10.1 Example for Configuring the Trunk

3.10.2 Example for Configuring a Trunk
3.10.3 Example for Configuring Communication Between VLANs Through VLANIF Interfaces
3.10.4 Example for Configuring VLAN Aggregation
3.10.5 Example for Configuring the MUX VLAN
3.10.6 Example for Configuring VLAN Damping
3.10.1 Example for Configuring the Trunk
Networking Requirements
As shown in
S9300, which connects to GE 1/0/1 of another S9300. Department 2 is connected a Layer 2
switch (LSW) LSW-A, which connects to GE 1/0/2 of an S9300. Department 3 is connected to
LSW-B, which connects to GE 1/0/3 of an S9300. Department 4 is connected to an S9300, which
connects to GE 1/0/4 of another S9300. The networking requirements are as follows:
Issue 03 (2009-08-20)
CAUTION
Figure 3-2, an enterprise has four departments. Department 1 is connected to an
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 VLAN Configuration
3-27