Copyright © 2010, Juniper Networks, Inc.
Figure 98: Do Not Rest the FPC on an Edge
Holding T1600 FPCs Vertically
NOTE: An FPC configured with PICs installed can weigh as much as
37 lb (14.5 kg). Be prepared to accept the full weight of the FPC as you lift it.
You hold an FPC vertically when installing it into the chassis. To hold an FPC vertically
(see Figure 99 on page 164):
Orient the FPC so that the faceplate faces you.
1.
Place one hand around the FPC faceplate about a quarter of the way down from the
2.
top edge. To avoid deforming the electromagnetic interference (EMI) shielding strip,
do not press hard on it.
Place your other hand at the bottom edge of the FPC. If the FPC has heat sinks about
3.
midway between the faceplate and connector edge, place your other hand against
the heat sinks.
Chapter 15: Maintaining T1600 Router Hardware Components
163