Verifying And Configuring The Upgraded Routing Engine As The Master; Figure 126: Installing A Routing Engine In An Mx960 Router - Juniper mx240 Hardware Manual

Verifying and Configuring the Upgraded Routing Engine as the Master

Copyright © 2016, Juniper Networks, Inc.

Figure 126: Installing a Routing Engine in an MX960 Router

After replacing the backup Routing Engine with the RE-S-X6-64G Routing Engine, perform
the following steps:
Verify that the SCBE2 and RE-S-X6-64G Routing Engine are online by issuing the
1.
show chassis hardware
After you install the RE-S-X6-64G Routing Engine into the SCBE2, the Routing Engine
2.
gets automatically powered on and comes up in amnesiac mode as it is loaded with
factory defaults. After the Routing Engine comes up in amnesiac mode, load the base
configuration and commit.
Configure the backup Routing Engine by using the
3.
copy the configuration to the backup Routing Engine.
Use the request chassis routing-engine master switch
4.
Engine RE-S-X6-64G (RE1) the master Routing Engine. All FPCs reboot after this step.
Chapter 24: Replacing Host Subsystem Components
command.
command to
commit synchronize
command to make the Routing
275