Verifying And Configuring The Upgraded Routing Engine As The Master; Verifying And Configuring The Upgraded Routing Engine As The Backup; Subsystem - Juniper MX960 Hardware Manual

Verifying and Configuring the Upgraded Routing Engine as the Master

Verifying and Configuring the Upgraded Routing Engine as the Backup

Related
Documentation
Upgrading to the RE-S-X6-64G Routing Engine in a Nonredundant Host Subsystem
Copyright © 2017, Juniper Networks, Inc.
After replacing the backup Routing Engine with the RE-S-X6-64G Routing Engine, perform
the following steps:
Verify that the SCBE2 and RE-S-X6-64G Routing Engine are online by issuing the
1.
show chassis hardware
After you install the RE-S-X6-64G Routing Engine into the SCBE2, the Routing Engine
2.
gets automatically powered on and comes up in amnesiac mode as it is loaded with
factory defaults. After the Routing Engine comes up in amnesiac mode, load the base
configuration and commit.
Configure the backup Routing Engine by using the
3.
copy the configuration to the backup Routing Engine.
Use the
request chassis routing-engine master switch
4.
Engine RE-S-X6-64G (RE1) the master Routing Engine. All FPCs reboot after this step.
Use the
1. request chassis routing-engine master switch
RE-S-X6-64G (RE0) the backup Routing Engine.
Use the
commit synchronize
2.
master Routing Engine to the backup Routing Engine.
RE-S-X6-64G Routing Engine Description on page 34
Upgrading to the RE-S-X6-64G Routing Engine in a Nonredundant Host Subsystem
on page 351
In a nonredundant host subsystem, only one Routing Engine and one Switch Control
Board are present in the chassis. When you are upgrading the Routing Engine, taking the
host subsystem offline shuts down the router. To upgrade the host subsystem with the
RE-S-X6-64G Routing Engine, you must uninstall the existing Routing Engine and install
the RE-S-X6-64G Routing Engine. Ensure that the Switch Control Board in the chassis
is SCBE2 because the RE-S-X6-64G Routing Engine is not compatible with the Switch
Control Boards SCB or SCBE. To upgrade the Switch Control Board to SCBE2, see
Replacing an MX240 SCB or Replacing an MX480 SCB or
page 409, depending on the chassis on which the Routing Engine is being upgraded.
Chapter 24: Replacing Host Subsystem Components
command.
command to copy the active configuration from the
command to
commit synchronize
command to make the Routing
command to make newly installed
"Replacing an MX960 SCB" on
351