Figure 139: Esd Point For Qfx10008 Chassis Front; Figure 140: Esd Point For Qfx10016 Chassis Front; Figure 141: Removing A Control Board Cover Panel - Juniper QFX10016 Hardware Manual

QFX10016 Switch Hardware Guide
240
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the front of the chassis (see

Figure 139: ESD Point for QFX10008 Chassis Front

1— ESD point

Figure 140: ESD Point for QFX10016 Chassis Front

Either remove the cover panel from the available Control Board slot (see
2.
Figure 141 on page 240) or remove the failing Control Board (see
Control Board" on page

Figure 141: Removing a Control Board Cover Panel

Remove the new Control Board from the electrostatic bag and inspect it for any
3.
damage before installing it into the chassis.
Lift the Control Board by its sides, being careful not to bump the connectors.
4.
Carefully align the sides of the Control Board with the guides inside the chassis.
5.
Figure 139 on page 240
1
241).
and Figure 140 on page
"Removing a QFX10000
Copyright © 2017, Juniper Networks, Inc.
240).