Connecting An Mx960 Ac Power Supply Cord - Juniper MX960 Hardware Manual

Connecting an MX960 AC Power Supply Cord

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
To connect the AC power cord:
Locate a replacement power cord with the type of plug appropriate for your
1.
geographical location (see
page 165).
Plug the replacement power cord into the corresponding appliance inlet located in
2.
the chassis directly above the power supply.
Insert the power cord plug into an external AC power source receptacle.
3.
NOTE: Each power supply must be connected to a dedicated AC power
feed and a dedicated customer site circuit breaker. We recommend that
you use a 15 A (250 VAC) minimum, or as required by local code.
Dress the power cord appropriately. Verify that the power cord does not block the air
4.
exhaust and access to router components, or drape where people could trip on it.
Move the AC input switch in the chassis above the power supply to the on (
5.
and observe the status LEDs on the power supply faceplate. If the power supply is
correctly installed and functioning normally, the
and the PS FAIL LED is not lit.
MX960 AC Power Supply Description on page 98
Disconnecting an MX960 AC Power Supply Cord on page 403
MX960 AC Power Electrical Safety Guidelines and Warnings
Replacing an MX960 AC Power Supply on page 391
Chapter 17: Connecting the MX960 Router to Power
"AC Power Cord Specifications for the MX960 Router" on
AC OK
— )position
and LEDs light steadily,
DC OK
243