Connect Power To The Ptx5000 Three-Phase Wye Ac Pdus - Juniper PTX5000 Quick Start Manual

Figure 26: Three-Phase Delta AC PDU
1
2
3
4
5
6
7
8
1 Top installation handle
—
2 Front installation handle
—
3 Power OUTPUT switch
—
4 Air exhaust ventilation
—

Connect Power to the PTX5000 Three-Phase Wye AC PDUs

To connect an AC power cord to a three-phase wye AC PDU (see
1. Switch off the customer-site circuit breakers. Ensure that the voltage across the AC power source is 0
V and that there is no chance that the voltage might become active during installation.
2. Switch the circuit breaker and power OUTPUT switch on the PDU faceplate to the off (O) position.
5 Circuit breaker
—
6 Wiring compartment
—
7 Wiring compartment door
—
8 Metal retaining bracket
—
Figure 33 on page 41):
36