Removing The Spacer Bars; Figure 35: Removing The Center-Mounting Bracket - Juniper T4000 Hardware Manual

Figure 35: Removing the Center-Mounting Bracket

Craft interface
Fan tray
FPCs
CIP
ESD point
Air filter
Fan tray
Air intake

Removing the Spacer Bars

Copyright © 2018, Juniper Networks, Inc.
Remove each bracket.
2.
Front-mounting flange
Center-mounting bracket
The router is shipped with each spacer bar attached to the rear of each front-mounting
flange. If you are installing the chassis in an open-frame rack, removing the spacer bars
is optional.
To remove the spacer bars:
Remove the screws that fasten the spacer bar to the front-mounting flange
1.
Remove the spacer bars.
2.
Chapter 16: Installing the Mounting Hardware
135