Installing An Mx104 Ac Power Supply; Figure 33: Removing An Ac Power Cord; Figure 34: Removing An Ac Power Supply - Juniper MX104 Hardware Manual

Installing an MX104 AC Power Supply

Copyright © 2014, Juniper Networks, Inc.

Figure 33: Removing an AC Power Cord

Figure 34: Removing an AC Power Supply

To install an AC power supply (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Using both hands, slide the power supply straight into the chassis until the power
2.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate or blank installed in the power supply slot.
Attach the power cord to the power supply.
3.
Secure the power cord with the power cord retainer clip.
4.
Attach the power cord to the AC power source, and switch on the dedicated customer
5.
site circuit breaker. Follow the instructions for your site.
Observe the status LED on the power supply faceplate. If the power supply is correctly
installed and functioning normally, the status LED lights green steadily.
Chapter 13: Replacing MX104 Hardware Components
Figure 35 on page 98):
97