Router Secured By Front-Mounting Brackets With Etsi Brackets; Installing The Rear Etsi Brackets; Installing The Rear-Mounting Brackets With Etsi Brackets - Juniper MX204 Hardware Manual

Copyright © 2018, Juniper Networks, Inc.
Install mounting screws into each of the open front-mounting holes aligned with the
7.
rack, starting from the bottom, and secure them tightly.
the router fully secured to the front rails of the four-post rack.
Figure 29: Router Secured by Front-Mounting Brackets with ETSI Brackets
Install the two rear ETSI brackets on the rear-mounting brackets (see
8.
Figure 30 on page 69).
The rear-mounting brackets on each side of the chassis are movable. You can adjust
the brackets according to the depth of the rack.
Figure 30: Installing the Rear ETSI Brackets
On the rear of the chassis, slide the rear-mounting brackets (with the ETSI brackets
9.
installed) on either side of the chassis until the rear-mounting brackets contact the
rack rails (see Figure 31 on page
Figure 31: Installing the Rear-Mounting Brackets with ETSI Brackets
Figure 29 on page 69
69).
Chapter 12: Installing the Router
shows
69