Figure 36: Installing The Mounting Brackets To The Front Of The Acx500; Figure 37: Installing The Mounting Brackets To The Rear Of The Acx500; Router - Juniper ACX500 Hardware Manual

ACX500 Universal Access Router Hardware Guide
110
CAUTION: Before front mounting the router in a rack, have a qualified
technician verify that the rack is strong enough to support the router's weight
(about 8.6 lb (3.9 kg)) and is adequately supported at the installation site.
NOTE: One person must be available to lift the router while another secures
it to the rack.
CAUTION: If you are mounting multiple units on a rack, mount the heaviest
unit at the bottom of the rack, and mount the other units from the bottom of
the rack to the top in decreasing order of the weight of the units.
To install the router in the rack:
Install both mounting brackets to either the front or rear of the chassis:
1.
Align the bracket with the two sets of mounting holes.
a.
Insert the four screws at the top and bottom of the bracket, and tighten each
b.
partially.
Tighten the four screws completely.
c.
Repeat the procedure for the other bracket.
d.

Figure 36: Installing the Mounting Brackets to the Front of the ACX500

Router

Figure 37: Installing the Mounting Brackets to the Rear of the ACX500

Router
Ensure that the rack is in its permanent location and is secured to the building. Ensure
2.
that the installation site allows adequate clearance for both airflow and maintenance.
Copyright © 2016, Juniper Networks, Inc.