Display references throughout this procedure are for illustration
purposes only.
See "General Information", "Features and Displays" and the
PC Unit Section of this DFU for information about:
• Displays
• Operating Features, Controls, Indicators
The majority of user interface programming is identical for both
p
Modules.
S
O
2
1.
Perform following steps (see PC Unit Section of this DFU,
"General Setup and Operation", "Start-Up"):
a.
Power on system.
b.
Choose Yes or No to New Patient?
c.
Confirm current profile or select a new profile.
d.
Enter patient identifier, if required.
2.
Attach patient cable and sensor (see "Getting Started").
3.
Press
CHANNEL SELECT
•
may appear in Channel Message display
SEARCHING
until
p
and pulse readings stabilize (approximately
S
O
2
seconds).
15
•
If sensor is not attached to a site,
displays.
•
To prevent screen from reverting to Main Display,
press
ENTER
screen displays.
•
If sensor is not attached during message display,
module goes into sleep mode. To begin monitoring
once module is in this mode, press
4.
Ensure sensor's red
®
Alaris
System (with v9 Model 8000) DFU
SpO
Modules Section
2
Monitoring Mode
key.
SENSOR OFF
key within
seconds after
30
is on.
LED
SPO2 Main
key.
MONITOR
Programming
% SpO 2
PULSE (BPM)
CHANNEL
SELECT
MONITOR
CHANNEL
OFF
4-3
Programming