Getting Started With Initial Connectivity; Introduction; Accessing The Device's Management Interfaces; Connecting To The Web Interface - AudioCodes M500Li Configuration Manual

1. Getting Started with Initial Connectivity

1 Getting Started with Initial Connectivity
1.1

Introduction

This part describes how to initially access the device's management interface and change its
default IP address to correspond with your networking scheme.
Device management can always be done through the LAN interface. It can also be
enabled for the WAN interface as explained in section 1.3.2,
Interface
1.2

Accessing the Device's Management Interfaces

This section describes initial access to the device's management interface.
1.2.1

Connecting to the Web Interface

You can access the Web- based management interface using the device's default LAN IP address:
By default, the device's embedded DHCP server is enabled for the LAN, and with default
IP pool addresses relating to the default subnet LAN. The DHCP server allocates this pool
of IP addresses to computers connected to its LAN interface. You can disable the DHCP
server or modify the IP address pool.
on page 7.
Table 1-1: Default LAN IP Address
Networking Parameter
IP Address
Prefix Length
Default Gateway
VLAN ID
- 4 -
Configuring the WAN
Default Value
192.168.0.1
24 (255.255.255.0)
0.0.0.0
1
M500Li Analog VoIP Gateway