Setup Parameters - Parker AC890 Product Manual

The following is a list of the Set-up parameters you may need to check before starting the drive. Set only
the ones marked with "x" for the intended mode of operation.
Note Parameters whose values are "product code dependent" will have a typical value for the size of unit.
Where possible (or required), enter an application-specific value for improved performance, otherwise
use the typical value.
Note "PREF" is a parameter reference number used by the DSE 890 Configuration Tool.
PREF
136.02
890SD (Standalone) Drive: Frame G, H & J
SET-UP PARAMETERS
Default
6511/6901 Display
0 : VOLTS / HZ
CONTROL
1 : SENSORLESS VEC
MODE
2 : CLOSED-LOOP
3 : 4-Q REGEN
4 : PMAC*
Brief Description
Select the operating
mode for the drive.
* If PMAC control is
VEC
required, the motor
wizard feature in the
890 DSE Configuration
Tool MUST be used to
correctly set-up the
motor and feedback
device parameters.
Failure to do so may
result in damage to the
servo motor.
890SD Standalone Drive
V/Hz SV CLV 4-Q
x x x
(0) (1) (2) (3)
Page
PMAC
x x
(4)
4-45