Resetting a Trip Condition
Before a trip can be reset, the trip condition must be removed.
Note
A Heatsink Over-temperature trip may not reset immediately. The unit needs to cool sufficiently.
Local Mode
To reset a trip in Local Mode:
Remove the trip condition
Remote Mode
To reset a trip in Remote Mode:
Remove the trip condition
Remove the trip condition
890SD Standalone Drive - Frames G, H & J
Press the Stop key to clear the trip. You can now press Run to
restart the system..
Press the Stop key to clear the trip. You can now press Run to
restart the system..
Alternatively, remove and re-apply the 24V supply at X01, or
-
toggle the ENABLE to 0V and then 24V to restart the system.
Trips and Fault Finding
Page
9-3